Thingiverse
Support for filament spools
by Giovanni1965
1
Downloads
0
Likes
0
Makes
Supporto bobine filamento con diametro foro 52 e 72 mm, ha la sede per un cuscinetto con foro 8mm, diametro 22 mm e spessore 8 mm, è un cuscinetto comune, stampate due supporti e vi serviranno due cuscinetti, lo montate tramite una barra filettata M8, per tenere fermo tutto usate un dado autobloccante, interponete una rondella tra gli appoggi dei cuscinetti e stringete il giusto per fare scorrere bene ma che non abbia gioco.
Filament spool support with hole diameter 52 and 72 mm, has the seat for a bearing with 8mm hole, diameter 22 mm and thickness 8 mm, it is a common bearing, you print two supports and you will need two bearings, you mount it through an M8 threaded rod , to hold everything in place, use a self-locking nut, place a washer between the bearing supports and tighten the right one to make it slide well but without play.
Filament spool support with hole diameter 52 and 72 mm, has the seat for a bearing with 8mm hole, diameter 22 mm and thickness 8 mm, it is a common bearing, you print two supports and you will need two bearings, you mount it through an M8 threaded rod , to hold everything in place, use a self-locking nut, place a washer between the bearing supports and tighten the right one to make it slide well but without play.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
