Thingiverse
Support for Hall sensor Y-endstop.
por Peter_I
2
Descargas
0
Likes
0
Makes
At first, my endstop was mounted with duct-tape.
This support goes on the back of it, making it much less fragile.
There is no mounting hole in the file. Simply drill it in the right location.
The Hall sensor sits below the pull-up resistor. It is a little hard to see the black sensor on a black background in the picture.
This support goes on the back of it, making it much less fragile.
There is no mounting hole in the file. Simply drill it in the right location.
The Hall sensor sits below the pull-up resistor. It is a little hard to see the black sensor on a black background in the picture.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
