Thingiverse
Support Settings Tester
von Elos
5
Downloads
11
Likes
1
Makes
This a small object I created in Fusion 360 to test support settings of your slicer. I tried to include some case where support is crucial:
- Print mid air
- slope to wall, slope away from wall
- round top
- print on object
- Print mid air
- slope to wall, slope away from wall
- round top
- print on object
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
