Surface Pop Lure

1 Piece Surface Lure I designed fusion 360 then Airbrushed (Work In Progress )

Uses eye bolts for line tie and hook connections.

Use small drill bit or heat a small nail to start holes for eye bolts to seat for hooks/line attachment.

Lighter Infill 30% or so will allow the lure to float/suspend

⚠️⚠️Until I can get predetermined hard points inserted into the body I recommend printing this at a dense infill (30% or greater) this just insures that the eyebolts have sufficient material to hold onto and not just pull out of the lure.⚠️⚠️

CHANGE SLICER UNITS TO MM or else HARDWARE WILL NOT FIT!

This thing makes plenty of noise as is but a rattle can be added in future versions.

CHANGE LOG

October 18, 2018 - Added a wide version that has a better defined mouth (better pop) and a wider tail that enables the eye bolt to be inserted without difficulty.

https://www.youtube.com/watch?v=9NCVeAyxofk&feature=youtu.be

Music: https://www.bensound.com