Thingiverse
SurfBoard Fin remover
door John_kapnisis
2
Downloads
1
Likes
0
Makes
Made this To remove my soft top surfboard fins instead of using a coin cause who caries coins?
Printed on my ender3
0.16 quality
100% infill
with support at an angle of 80degrees
PETG but pla will work fine
Printed on my ender3
0.16 quality
100% infill
with support at an angle of 80degrees
PETG but pla will work fine
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
