Thingiverse
Surgical Mask Strap Stand
by mmasson
53
Downloads
37
Likes
2
Makes
This is a stand to carry the straps. Prints without supports.
The post friction fits to the base, so you just put the post in the base from the bottom.
You can prevent the straps from falling for transport by putting a zip tie in the top hole.
It is made to fit these straps: https://www.thingiverse.com/thing:4249113
UPDATE: Post v2 uses less plastic.
Other model: https://www.thingiverse.com/thing:4325090
To fit this strap: https://www.thingiverse.com/thing:4271014
The post friction fits to the base, so you just put the post in the base from the bottom.
You can prevent the straps from falling for transport by putting a zip tie in the top hole.
It is made to fit these straps: https://www.thingiverse.com/thing:4249113
UPDATE: Post v2 uses less plastic.
Other model: https://www.thingiverse.com/thing:4325090
To fit this strap: https://www.thingiverse.com/thing:4271014
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
