Thingiverse
Sus rock keycap
von virkant_
63
Downloads
91
Likes
0
Makes
THIS IS A REMIX OF : https://cults3d.com/en/3d-model/art/sus-rock
sliced with cura 5.0.0
I had to print it sideways for best results(look at 2nd image). Printing it sideways reinforces the bond between the model end the keycap bottom
support overhang angle: 60
support placement: touching buildplate
keycap works for cherrymx type stem
the hole for the switch stem is a bit bigger than the actual stem. I had to make it that way otherwise it wouldnt fit(at least not with my printer which is calibrated). If it feels the hole is too big just put a piece of paper in it.
sliced with cura 5.0.0
I had to print it sideways for best results(look at 2nd image). Printing it sideways reinforces the bond between the model end the keycap bottom
support overhang angle: 60
support placement: touching buildplate
keycap works for cherrymx type stem
the hole for the switch stem is a bit bigger than the actual stem. I had to make it that way otherwise it wouldnt fit(at least not with my printer which is calibrated). If it feels the hole is too big just put a piece of paper in it.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
