SV08 BLTouch/3DTouch Probe Mount

A BLTouch or 3D touch probe mount for your SV08. Do NOT use the 24v power pin on the connector and use an alternative 5V pin.It will require a modified toolhead cover to allow for the fit as it sticks out the side. Use my alternative Toolhead cover. SV08 Minimal Toolhead cover with LED by EternalGnome | Download free STL model | Printables.comchange the x offset to 20.5 mm, and the y offset to 6 mmPrint with high temp ASA, ABS, or PETG.Use a few M3 screws and nuts. 12mm, 6mm and 8mm. Standard version is for the stock standard length (28.2mm) nozzle as well as the Hardened steel nozzleShelf version adds a small nut shelf to make it easier to install.Let me know if you need a shorter or longer one for other nozzles. After installation.Turn on your printer, BLtouch pin should self test.Edit printer.cfgComment out the [probe] sectionAdd [bltouch] section (change values as needed):[bltouch] sensor_pin: ^extra_mcu:PB6 control_pin: extra_mcu:PB7 x_offset: -20.5 y_offset: 6 z_offset: 0 pin_mov