SVO2 Purge Bucket and GCODE

This is a remix of https://www.thingiverse.com/thing:3485963 but when I try to make a remix of the original design thingiverse won't let me. Make sure you check out the original design and information.

You have to remove the two roller bearings on the right side of the X gantry to install the bucket.

You will need some 1/16" or 1.5mm silicone sheet. I had a bunch from another project, there are lots of ways to get some. I've even seen people cut if from silicone cooking utensils or other cooking supplies.

I print the bucket standing up with supports.

I use Cura, and all the material changes are done within the End code of each extruder. Nothing is written in Start code for the extruders! I have copied and pasted the start and end codes I'm currently using for the printer, as well as the end codes for each extruder below. FYI this is not perfect, I'm no expert so you will likely end up changing things. There is a M104 to set the temp to 216. This was to try and prevent a de