Thingiverse
SW-Motech Trax Mount
von RBBuilds
1
Downloads
3
Likes
0
Makes
Made this so I can hang my Trax cases on the wall when Im not using them. Made the hole countersunk so screws will sit flush.
You will need to mount these to apiece of 1x2 or something similar to create a spacer so that the locks will clear the wall.
You will need to mount these to apiece of 1x2 or something similar to create a spacer so that the locks will clear the wall.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
