Swearing Ghost

I generated this model using Hunyuan3D 2.0 AI generator, and then fixed it up and added hollow eyes in Tinkercad, and then added a coloured 3mf version in Bambu Studio. I have not yet tested the 3mf black eye version, but the single colour prints lovely on my H2S. You could always use a fine tip black marker to colour in the eyes and cut down on print time/waste. Any feedback on this model would be greatly appreciated as I'm still learning. Thanks :) Edit - I have just found the original creator of this design (I generated this model based on a photo), so please go and check out VERNARA's model https://makerworld.com/en/models/1743163-middle-finger-ghost-halloween-stl-flip-off#profileId-1852705