Swing seat canopy adjuster

A swing seat canopy adjuster I made for a friend. The original part broke for him, so I designed this one instead.The dimensions of the connecting faces are based on the original one, but the rest has been optimized for 3D printing. There are a couple of things that has to be done after printing the parts: Part1:Remove the sacrificial layer from the screw holes. Their only purpose is to make this part printable without support.Part2:Remove the small tabs on the outside under the edges with a blade. Their only purpose is to make this part printable without support.Insert a "Sleeve Converter Nut" to the hole --> OD: 14mm, ID: 10mm, Length: 20mm max.Note: The side holes that can be seen on the pictures have been removed from the design. They were not necessary, the piece was a tight fit in the swing seat frame anyways.Star_knob:Remove the sacrificial layer from the screw hole. It's only purpose is to make this part printable without support.Insert an M10x50 hex head screw (DIN