Swirl Jugs

Four different versions for your 3D printing pleasure. UPDATE: found one I left out; see downloads for new file. It was the one on the right in the photo.
I used Chroma Strand Labs Inova-2008 3mm (PETg) transparent. Great stuff, no stink, food safe, no warp, but needs Elmer's glue stick on PEI. Fan or no fan seems not to make any difference. After a few layers I increased the material feed to 115% but I am not sure that was necessary. Just wanted to make sure there was adequate material extruded.
These are solid models that were setup in vase, single outline corkscrew mode. 3 bottom layers, zero top layers. 235C/80C nozzle/bed temperatures. The models are completely solid and must be set up in your slicer to produce a vase, unless for some strange reason you want to waste material on a solid lump.
If 3 or 4 people ask I will modify the files so they can be printed with thicker walls instead of just single wall.

Note: AngleSpy made the comment that the print came out to