MakerWorld
Electronics
Go to Model
Switch 2 & Switch 4-Cartridge Case
341
Downloads
101
Likes
243
Makes
A small, print-in-place cartridge case that holds 4 game cards for Nintendo Switch 1 or 2 (both use the same cartridge size). Designed to print without supports, with strong, integrated hinges that work straight off the bed.The fit is snug to keep cartridges in place, but small finger notches make them easy to remove. The hinge design is reinforced for daily use, and the overall form is compact and travel-friendly.Works best when printed in PLA or PETG at 0.2 mm layer height or finer. No supports or assembly required.
LayersLab also publishes on
59 additional models across 2 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
