Thingiverse
Switch and connector Box
door FourOfFour
4
Downloads
2
Likes
0
Makes
Connecting the power line to the usual power supplies too often ends up in risky designs.
To safely connect a standard wire to a Prusa I3 Steel, I designed this box.
It holds the plug's connector and a 2-pole switch to allow turning on and off without pulling a plug.
Pirnted in colorless material, internal LEDs easily signal that the printer is powered.
The box solidly clamps to the metal frame of the i3 steel when tightening the screws.
Screw type is cylindrical hex-screws in M3 x 35mm.
Can easily be printed without support.
To safely connect a standard wire to a Prusa I3 Steel, I designed this box.
It holds the plug's connector and a 2-pole switch to allow turning on and off without pulling a plug.
Pirnted in colorless material, internal LEDs easily signal that the printer is powered.
The box solidly clamps to the metal frame of the i3 steel when tightening the screws.
Screw type is cylindrical hex-screws in M3 x 35mm.
Can easily be printed without support.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
