SwitchBot CO2 Sensor Wall Mount Drywall Pin Type

Mount your SwitchBot CO2 sensor (2nd gen) directly onto a drywall without any IKEA SKADIS panel. This is a wall-direct variant of the popular SKADIS holder, using the same rear rivet holes of the sensor for a minimal and clean attachment. ## Features - No SKADIS required — mounts directly to drywall - Uses the sensor's built-in rear rivet holes (no screws into the sensor) - Designed for standard 3-pin drywall push pins (widely available) - Minimal footprint, keeps the sensor flush against the wall - No support material needed ## What You Need - SwitchBot CO2 Sensor (2nd generation) - 3-pin drywall push pins × 1 set (standard type, available at home centers) ## Print Settings - Layer height: 0.2mm - Walls: 2 - Infill: 15% - Support: None - Material: PLA or PETG recommended - Orientation: Print with front face down ## Compatibility - ✅ SwitchBot CO2 Sensor (2nd gen) - ✅ Standard drywall (石膏ボード) - ✅ 3-pin push-type drywall anchors --- 🇯🇵 **日本語補足** SwitchBot CO2センサー（第2世代）を石膏ボードに直接取り付けるホル