Thingiverse
Swivel Latch/Clamp
by BryanHaley
36
Downloads
16
Likes
0
Makes
Needed something to hold the door of my 3D printer box closed tight; came up with these.
"Left" and "Right" versions refer to the side of the box the latch is intended to be attached to (with the axel cap facing down). If you don't care about the axel cap facing up or down, they are reversible.
A "long" version is included that extends the finger of the latch. It is what's shown in the first photo.
If necessary, glue a bit of sandpaper to the finger to give it a little extra grip.
"Left" and "Right" versions refer to the side of the box the latch is intended to be attached to (with the axel cap facing down). If you don't care about the axel cap facing up or down, they are reversible.
A "long" version is included that extends the finger of the latch. It is what's shown in the first photo.
If necessary, glue a bit of sandpaper to the finger to give it a little extra grip.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!