Thingiverse
Swix ski pole strap lock
2
Downloads
1
Likes
0
Makes
Material: PLA/PLA+
Layer Height: 0,2
Infill Density: 30 %
Support: No
Adhesion: No
Tip: Print with "top" down. Widest square part without spike facing down. then you don't need support.
Layer Height: 0,2
Infill Density: 30 %
Support: No
Adhesion: No
Tip: Print with "top" down. Widest square part without spike facing down. then you don't need support.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
