Syma Mini Hovercraft

My Syma Sky Thunder RC D63 Drone wasn't performing correctly, so I made a hovercraft conversion for it.

I printed it in PETG on my cr-10. The body needs supports.

Assembly:
I had to unsolder the motor wires from the board cause they are through the quadcopter frame. If you wanted to 1-way convert this you could just cut the copters frame arms.

I used the small screws to mount the mother board onto the body. Make sure the board faces forwards. Your forward props have room for the wires to be routed through the channels in the body.

Use an elastic band to hold on the battery on the board.

If I have to reprint this I will modify the design as the tolerance on the prop guards is too close. If I do I will re-upload

Also the skirt will let you get up onto carpet. The skirt is slower so, no skirt on smooth surfaces is the best.

It's a little back heavy.