Thingiverse
T-Caliper
por jonweb
2
Descargas
1
Likes
0
Makes
Hello Gentlemen, this is an addon for your caliper in order to trasform the orginal one to a T-Caliper to use to measure deep holes,steps, others.
I adapted it to my caliper MIB Germany 200 mm, but it is very to adptive modfing the drawing. Inside the hole for the caliper arms i add a little slide to avoid problem when you will block it by screw. The hole for the screw has been made in ordet to add a M3 RUTHEX insert. In order to tighten use a M3x12 screw
I adapted it to my caliper MIB Germany 200 mm, but it is very to adptive modfing the drawing. Inside the hole for the caliper arms i add a little slide to avoid problem when you will block it by screw. The hole for the screw has been made in ordet to add a M3 RUTHEX insert. In order to tighten use a M3x12 screw
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
