Thingiverse
T-Copter Frame
von tmlowe
1
Downloads
3
Likes
0
Makes
This is the main body frame for a T-Copter
This is a project and i will be posting more pictures
This will accommodate a receiver, a 100mmx 25x 35mm battery and 3 ESCs on the lower piece (the piece without the square holes) and a kk2(.0 or .1) board on the top. i am using 1/2 inch square wooden dowels for the arms and NTM 800kv outrunners for the motors and HobbyKing 30amp speed controllers.
This is a project and i will be posting more pictures
This will accommodate a receiver, a 100mmx 25x 35mm battery and 3 ESCs on the lower piece (the piece without the square holes) and a kk2(.0 or .1) board on the top. i am using 1/2 inch square wooden dowels for the arms and NTM 800kv outrunners for the motors and HobbyKing 30amp speed controllers.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
