Thingiverse
T-TRAK-Z alignment tool
von JoshMurrah
19
Downloads
12
Likes
0
Makes
A simple minimal T-TRAK-Z alignment tool.
Use as shown to set your tracks to 3" centerline on front, and 25mm spacing between front and rear track.
Drill out the molded tube underneath the track section and screw/nail to secure.
Some additional white or wood glue is also recommended along the edge, for security on the module.
Use as shown to set your tracks to 3" centerline on front, and 25mm spacing between front and rear track.
Drill out the molded tube underneath the track section and screw/nail to secure.
Some additional white or wood glue is also recommended along the edge, for security on the module.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!