Thingiverse
t16 magnetic screen mount
von PencilCore
0
Downloads
0
Likes
0
Makes
You need a 1.5cm radius round magnet, and two m3x12 screw to made this thing.
And also you need to set 2 holes in your slicer, 5.5mm each, as shown in the photo above.
Thats all, be sure to stick a powerful magnet on the back of your screen too, it's designed specificlly for screens below 3.5 inch.
for weaker magnets use a rubber band to attach.
And also you need to set 2 holes in your slicer, 5.5mm each, as shown in the photo above.
Thats all, be sure to stick a powerful magnet on the back of your screen too, it's designed specificlly for screens below 3.5 inch.
for weaker magnets use a rubber band to attach.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
