T95 Android Box Cooling Fan Stand

Created this to help bring down board temperatures on the T95mini during multiple instances of Klipper use while in a garage.
Doubles as a stand and active cooling setup. It forces air up through the vents across the board and cooling block out the top.
There are M4 threads built into the model for the fan bolts to thread into.
Any of the T95 size units should fit into this including the Inovato Quadra, T95max, etc.

Performance:
Prior to this active cooling stock unit was averaging 85C-100C under load in 25C environment.
Using this brought down board temperatures to averaging 45C in 25C environment.

* supposedly many of the T95 units have a poor factory thermal paste application both in surface area as well as air gaps, your unit may need a fresh application of a thermal paste.


Parts:
x4 - M4 bolts, length depends how far you want it off the table, believe I used 45mm
x4 - M4 nuts
x1 - 70mm x 70mm fan any standard fan will work.
I used this 5500rpm one from amazon