Thingiverse
Table Corner Headphone Holder v1
por PantherCookies
2
Descargas
4
Likes
0
Makes
This corner headphone holder printed for me in about 9hrs at 20% infill and 0.3mm layer height on a cr-10s pro.
I may add a screw hole soon so that you can screw it into the table from below.
Fits
- Tabletop: 26mm high
60mm into the table on each side (above and below on x and y)
- Headband+cushion: 25 MM
I may add a screw hole soon so that you can screw it into the table from below.
Fits
- Tabletop: 26mm high
60mm into the table on each side (above and below on x and y)
- Headband+cushion: 25 MM
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!