table headset stand.

by Manufactorum_3D · Office

51 Downloads

13 Likes

9 Makes

Headset stand with 45.6 mm thick headband, can be attached to tables between 10 to 50 mm. Print at 0.2mm layer height. Without supports, recommended: use of brim in stand piece or lac to prevent warping. use PETG material instead of PLA.density greater than 30%.4 walls, 3 top and bottom covers.Print orientation as shown in the gif below:

stand cascos support headset headset accessory headset cable holder heatsetholder holder Holder auriculares headphones headphones accessory pcaccessories gamer gamer accessories gamer accessory Stand stand headsetstand