Thingiverse
Table lamp holder clamp
by Deian
51
Downloads
64
Likes
0
Makes
-You will need 1x M8 bolt and 2x M8 nut's
-You should print this part with an higher infill
-The inner diameter off the hole fore the lamp is 13mm
-The fit for the M8 nut's is snug and needs to be forced into position
If you found my Things useful, treat me to a cup of coffee : https://ko-fi.com/deiandex98
-You should print this part with an higher infill
-The inner diameter off the hole fore the lamp is 13mm
-The fit for the M8 nut's is snug and needs to be forced into position
If you found my Things useful, treat me to a cup of coffee : https://ko-fi.com/deiandex98
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
