Table lip for Ikea MITTZON

A simple table lip that uses two slices of 2mm thick craft foam to hold onto the table without scratching it. It’s capable of securely holding an older, heavy laptop without any issues. While it can be a bit stiff to slide on the first time, starting with one corner makes it easy.I designed this because I wasn’t satisfied with the original part provided by Ikea, as it only works in the center. I prefer to have a book or my laptop to the side and frequently remove the lip depending on the task, which would likely scratch the table over time. Additionally, I wanted something that stays closer to the edge of the table. I printed it in ASA but some of my test prints were printed in PLA and worked without any issues