Table/stool leg leveller

This is a jig for levelling the legs of a table or stool, and making the leg feet parallel to the floor. Start by shimming your table/stool so it's parallel to the surface, then put the main jig over one of the legs, saw through the leg, then replace the jig with one of the spaces (it helps to tape it to the bottom of the leg), then move to the next leg etc. There's a fairly generic model attached, with a 10mm cutoff height, and a 2mm kerf, for up to a 40mm diameter leg, but you'll get better results if you use the parametric Customise option to make one specific to your saw. I printed it in PETG HF, but PLA would probably work, it just wont last as long. The orientation is quite strange, and the printed has a hard time printing the space for the leg, but the most important thing is the accuracy and strength of the kerf slot.