Thingiverse
table tennis racket
por sk3lett
4
Descargas
25
Likes
0
Makes
This is my design of a fully 3D printable table tennis bat. No supports or screws are required. The rubbers are printed with TPU. The rubber is connected to the racket via a specially designed connection that clamps two small rubber blocks on each side of the rubber when both rubbers are joined together. The red rubber file is the same as the black one. so there are only 3 files. It is recommended to use 50% infill for the Rubber sides, because of the density of the small clamping blocks. Feel free to share a make.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
