MakerWorld

Electronics

Table Top MagSafe Charger

von BD3D · Electronics

16 Downloads

4 Likes

11 Makes

MagSafe table top/end table charger. Screws into back of table with 4 screws to hold unit down. NOTE: THIS WILL NOT FIT THE APPLE BRANDED MAGSAFE CHARGER. This model fits and after market MagSafe charger that I purchased on Amazon (Puck dimensions: 60mm diameter, 8mm thick) https://a.co/d/8un2Js9 I wanted a MagSafe charger on my end table but did not like the fact that I could not take the phone off the charger without the charger moving or requiring 2 hands. Modeled with a fairly large USB-C cable so most if not all cables will work with this model I DO NOT RECOMMEND USING MATTE PLA AS MAGSAFE PUCK MAY NOT FIT. RECOMMEND USING BASIC PLA

Charger end table mag safe mag-safe magnetic charging MAGSAFE phone accesories phone accesory phone accessiories phone charger table top tabletop Wireless Wireless Charger wireless charger base wireless charger holder

Kategorie

Electronics

Quelle

MakerWorld

Veröffentlicht

23.09.2025

Aktualisiert

19.05.2026

Was du zum Drucken brauchst: Mittel Niedrige Konfidenz

Einteilig Hardware nötig

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 1/3

Drucker

FDM / FFF

Dateiformat

STL

Material

PLA

Nachbearbeitung

Hardware

Software

Cura, PrusaSlicer o. Ä.

Noch keine Bewertungen

Noch keine Kommentare – sei der Erste!

Table Top MagSafe Charger

Ähnliche Modelle

Zur Sammlung hinzufügen