Table top Mini Foosball

Mini Foosball table. Two Thirds version (with mods, see below) of Table Soccer by Ace24.

Infill varies depending on the part. Playing surface at 25%. Players at 60%. Nets, end knobs, counters at 50%.

Mods:
Scaled to 2/3
Revised nets with holes
New players
Use of wood dowels instead of printed bars

Modification work done in Sketchup

EDIT (October 13, 2024):
By request, added in files for the control rods. These files will would replace the wood the dowels. There are two versions. One uses a 5.5mm diameter, the other uses a 5.0mm diameter. Depending on your printer and whether you chase the holes in the base with a drill bit, one or the other will fit better. I think I'd print them laying down for best strength, however this will like require supports and a bit of trimming / sanding. Note that I have not tested the game with the printed rods. DvdH.