MakerWorld
Organizers
Go to Model
Tablet holder for tables
46
Downloads
27
Likes
16
Makes
Didn't find a tablet holder that can be attached to a table or a desk so i modelled this one. It has a slit at the front and a hole at the bottom so you can use it with a charging cable. The first one has 2.5cm (around 1 inch) space between the two brackets, the second one has 5cm (around 2 inches). You should check the thickness of your desk beforehand. I added a brim because i was scared for it to fall over but maybe it works without. I printed it in ABS because that's what i had but i guess you could also print it in PLA or PETG.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
