Thingiverse
Tablet Mount Vesa 100x100
door DoingMyThing
15
Downloads
11
Likes
0
Makes
Looking for a simple 10-13” tablet VESA 100x100 mount? Look no further! I couldn’t find anything that would fit a 10” and 12” tablet and ‘hold’ it in place, so I made this.
It's very simple and all you need are two small elastic bands. It's not extremely refined as it's my first 3d print build ever. However the first one I printed worked perfectly after cutting off the brim I printed it with. Open to feedback and feel free to remix (with credit).
Printed at 0.3mm, without supports and with 25% infill in 6.5 hours (5.25h+1.25h). I would suggest printing it at a higher quality and without a brim. Infill at 25% may be overkill as it's very strong.
V1 is the version I printed and am using
V1.1 (BETA) was refined slightly:
- resized the slide arms to slide better at draft print
- added multiple notches on the slide arms to increase tension
- repositioned the base frame a bit for aesthetics
Using it with a Samsung Galaxy Tab A8 10.5” and Microsoft Surface Pro 7.
As th
It's very simple and all you need are two small elastic bands. It's not extremely refined as it's my first 3d print build ever. However the first one I printed worked perfectly after cutting off the brim I printed it with. Open to feedback and feel free to remix (with credit).
Printed at 0.3mm, without supports and with 25% infill in 6.5 hours (5.25h+1.25h). I would suggest printing it at a higher quality and without a brim. Infill at 25% may be overkill as it's very strong.
V1 is the version I printed and am using
V1.1 (BETA) was refined slightly:
- resized the slide arms to slide better at draft print
- added multiple notches on the slide arms to increase tension
- repositioned the base frame a bit for aesthetics
Using it with a Samsung Galaxy Tab A8 10.5” and Microsoft Surface Pro 7.
As th
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
