Thingiverse
Tablet Stand - MPMD Size
von noimjosh
5
Downloads
1
Likes
0
Makes
My wife needed a stand for her Nook, and my larger printer was in pieces. So, I figured out the maximum size I could print on my Monoprice Mini Delta.
After a few rounds, and modifications I decided to upload them here.
Changes:
- It's smaller (84% the size of the original to fit the MPMD)
- It's designed to be held together using 4 M3 screws (anywhere from 6mm to around 20mm should work)
- The bottom lip is extended to fit devices up to 16mm thick
After a few rounds, and modifications I decided to upload them here.
Changes:
- It's smaller (84% the size of the original to fit the MPMD)
- It's designed to be held together using 4 M3 screws (anywhere from 6mm to around 20mm should work)
- The bottom lip is extended to fit devices up to 16mm thick
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
