Tablet Wedge Stand

While sitting at the kitchen table my tablet is at a very low angle to me, but the lights reflect off the screen if it's not propped up a little. I was tired of putting the salt shaker under the top to hold it up, so I made this little wedge to hold it instead. Mostly just playing with shapes in TinkerCAD, but it ended up like this - prints cleanly without supports. Rubberized no-slip tape on the bottom helps hold it in place.I think they look great in Wood PLA, but I'd love to see what colors you print it in! THE V WEDGEThis one is a little smaller, and I found it a bit unstable for full-sized 10" tablets. Still worked, but if I aggressively tapped the top of the screen it'd wobble a little bit. Works great for smaller 8" ones though. THE U WEDGEMade this one a bit beefier, holds a 10" tablet much more stably. Note: the STLs have some oddities inside them. If you're going to load them directly, please fix them in BS.