TableTop / Board Games, extra space on your table

I found the idea to double the space on your table or to level up your table to play table top games totally cool. So I designed these tiles.

The basic design is a square with 15 cm length.

To set up the board you first need to connect all tiles in one row. Then connect all the rows to form your extra space on your table.

For printing, print the upper parts upside down (with the surface you would later be playing on facing the hot bed), so no supports are needed (except for the stabilizers). Lower parts can be printed in the way they are loaded into the slicer.

When the parts that I am printing are finished I will upload a couple of more photos.

What you need:

For basic Set Up (about 45 cm x 90 cm an about 15 cm high) you need:
2 x Corner_1
2 x Corner_2
4 x Inner
5 x Side_1
5 x Side_2
6 x Foot
12 M6 nuts
6 threaded rods M6 in whatever length you wish to raise your extra space (e. g. 15 cm).
6 Stabilizers (you can but don't have to glue the stabilizers under