Thingiverse
Tactacam Bow Mount
von branj252
0
Downloads
0
Likes
0
Makes
Mount designed to mount a Tactacam Solo Xtreme to a bow stabilizer.
This uses an M4x14 or longer bolt to hold the camera in and a 5/16-20 x 3.5" bolt to mount the cam to the stabilizer hole on the bow. The inside is intended to printed out of TPU to prevent scratching the camera and act as a shock absorbing layer. I may need to adjust the length that it sits out from the bow or add a TPU cap for the bolt end where it mounts to the bow.
This uses an M4x14 or longer bolt to hold the camera in and a 5/16-20 x 3.5" bolt to mount the cam to the stabilizer hole on the bow. The inside is intended to printed out of TPU to prevent scratching the camera and act as a shock absorbing layer. I may need to adjust the length that it sits out from the bow or add a TPU cap for the bolt end where it mounts to the bow.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
