Thingiverse
Tactical Sharpie Cap
von AlwaysStoney
40
Downloads
91
Likes
0
Makes
This fits a standard felt-tip sharpie marker.
I printed this with supports on only the clip of the cap. I used a support blocker to stop it from printing supports inside the marker cap.
Print with 99% infill (not 100% or Cura will change your top/bottom layer #'s).
Resolution: 0.2mm
I printed this with supports on only the clip of the cap. I used a support blocker to stop it from printing supports inside the marker cap.
Print with 99% infill (not 100% or Cura will change your top/bottom layer #'s).
Resolution: 0.2mm
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
