Thingiverse
Tactical X Carriage
by pin13
844
Downloads
532
Likes
8
Makes
Print at .2mm layer height and .4mm nozzle width.
Infill doesn't have to be more than 20% even with PLA for good performance. Heavier carriage will induce more 'ringing' artifacts, so no need to over do it.
https://youtu.be/lC0DSHMy9x8
https://youtu.be/GrBnLkITbCA
Fantasic video of assembly and installation: https://www.youtube.com/watch?v=B0B2--2LZ9k
- big thank you to GeorgesGadgets for putting this together!
#### Features
* Lightweight
* Easy to print
* No supports required
* Multiple hotends supported
* Chimera/Cyclops
* Stock Tarantula hotend
* E3D V6 Genuine/Clone
* Quick-swap
* switch hotends in seconds
* Stock V-wheel or MGN12 rail
* Makes it easy to start with V-wheel and upgrade to rail
* Clean wiring solution
* Integrated layer cooling
* Using blower fan for higher pressure
* Two options for fan placement
* Swappable duct for experimenting with different designs
* BLTouch mount
Infill doesn't have to be more than 20% even with PLA for good performance. Heavier carriage will induce more 'ringing' artifacts, so no need to over do it.
https://youtu.be/lC0DSHMy9x8
https://youtu.be/GrBnLkITbCA
Fantasic video of assembly and installation: https://www.youtube.com/watch?v=B0B2--2LZ9k
- big thank you to GeorgesGadgets for putting this together!
#### Features
* Lightweight
* Easy to print
* No supports required
* Multiple hotends supported
* Chimera/Cyclops
* Stock Tarantula hotend
* E3D V6 Genuine/Clone
* Quick-swap
* switch hotends in seconds
* Stock V-wheel or MGN12 rail
* Makes it easy to start with V-wheel and upgrade to rail
* Clean wiring solution
* Integrated layer cooling
* Using blower fan for higher pressure
* Two options for fan placement
* Swappable duct for experimenting with different designs
* BLTouch mount
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
