Thingiverse
Tacx Flow Cooling Fan
por stephenwalker78
5
Descargas
1
Likes
0
Makes
This is a thing to add a standard 80mm cooling fan to your Tacx trainer.
The bolt holes are at 71.5mm spacing and take an M4 countersunk screw (M4 x 35mm in the picture is a bit long - M4 x 25mm would be better).
It fixes directly into the 50mm aperture in the Tacx trainer (you need to remove the small circular guard in the centre of your trainer - it just pops out).
The push-fit on the STL file is at exactly 50mm diameter - if it's a loose fit, just wrap a thin layer of tape and trim, then it'll push-fit like a dream.
Happy (cool) cycling :)
The bolt holes are at 71.5mm spacing and take an M4 countersunk screw (M4 x 35mm in the picture is a bit long - M4 x 25mm would be better).
It fixes directly into the 50mm aperture in the Tacx trainer (you need to remove the small circular guard in the centre of your trainer - it just pops out).
The push-fit on the STL file is at exactly 50mm diameter - if it's a loose fit, just wrap a thin layer of tape and trim, then it'll push-fit like a dream.
Happy (cool) cycling :)
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
