Thingiverse
Tail whee strut
di canamar
5
Download
2
Likes
0
Makes
The print comes out in two parts. the fuselage strut and the rudder clamp as seen in the image above. This is much like the one found on the hobbyzone super-cub. the rear of the fuselage strut is fits 18mm fuselages and the front fits 20mm fuselages. the whole for the landing gear is 2mm in diameter.
When printing, print it in the same orientation as in the first image, remember to use supports when printing it.
When printing, print it in the same orientation as in the first image, remember to use supports when printing it.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
