Thingiverse
Taillight and Flag Support - Rack Mount
von LoadMaster1
2
Downloads
0
Likes
0
Makes
This attaches to my trike rear rack to allow mounting a taillight and supporting the flag. It is held in place using tie wraps. It is made in two pieces. the main support and a rear triangle piece. I use brass nut inserts that are heated to install. This gives a good secure attachment for the reflector triangle piece.
No supports are needed for this print.
I use 3D Fuel PLA Pro Plus. It is strong and holds up to outdoor UV.
No supports are needed for this print.
I use 3D Fuel PLA Pro Plus. It is strong and holds up to outdoor UV.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
