Slicer Discord
Talaria X3 Tail Extender v2 – Modelo 3D imprimible de MakerWorld MakerWorld
Vehicles

Talaria X3 Tail Extender v2

99 Descargas
23 Likes
38 Makes
Ver Modelo
I created this to prevent water / mud from flying up onto my back and helmet, and to add some sharpness to the esthetics of the bike. Bill of Materials:2 - M4 x 6mm screws2 - M4 nuts I found it best to use magnets to keep / guide the nuts into place after the mounts are put on. The printing profile in the 3mf is what I did to keep color changes low, but if you want better quality layers, turn it however suits your needs. Change log:2024-12-18: Updated model to only require 2 screws / nuts. Screws are now internal so the outside is smooth (no screws visible on outside). Added STEP files and 3mf.2024-07-12: Added small strengthening chamfers and fillets to bracket mounts.2024-07-10: Added new model with no vents.2024-02-11: Added new contour style.2024-02-10: Widened screw holes. Extended mount bracket frame side length.2024-02-09: Fixed artifact in the underside geometry. Thickened connections on mount bracket.2024-1-2: Rounded vent edges.2023-12-27: Updated outer-most edge to be thicke
Categoría
Vehicles
Fuente
MakerWorld
Publicado
Actualizado
Lo que necesitas para imprimir: Avanzado Baja confianza
¿Por qué?
impresión muy grande · postproceso considerable
Pieza única Tornillería requerida Puede necesitar escalado
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 3/3
Postproceso 2/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
PLA
Cama mín.
300 mm (Muy grande)
Postprocesado
Lijado, Tornillería
Software
Cura, PrusaSlicer o similar
Mismo diseñador, más plataformas

thegestalt también publica en

7 modelos adicionales en 1 plataformas más

Verificado por coincidencia de títulos de modelos entre plataformas.
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

5 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección