Slicer Discord
Talkbox adapter for phone – 3D-Druckmodell von MakerWorld MakerWorld
Music

Talkbox adapter for phone

von 42Towels · Music
6 Downloads
3 Likes
9 Makes
Zum Modell
This full-width sleeve clips snugly over the bottom edge of an iPhone 16 Pro and captures the right speaker's output through a sealed chamber, funneling it straight down through a barbed nipple into standard 3/8" ID vinyl tubing (aquarium or utility tube, available at any hardware store). What you need: ~3–4 ft of 3/8" ID clear vinyl tubing (hardware store, ~$1–2) Optional: thin closed-cell foam tape (3M weatherstrip) applied around the inner rim of the floor for a better acoustic seal against the phone Usage: Slide adapter onto the bottom of your iPhone 16 Pro, right edge flush Press 3/8" vinyl tube firmly onto the barbed nipple Put the free end of the tube near your mouth Play audio from your phone — music, synth app, voice Shape the sound by mouthing vowel sounds without vocalizing
Kategorie
Music
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA, TPU
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen