Thingiverse
Talon Mag Markers
por bamboost
38
Descargas
19
Likes
1
Makes
Spruce up your talons with some snap-fit mag markers!
modeled after the magpul pmag, you'll have the spiffiest mags on the field.
tolerance is 0.15mm from the mag so print this with good quality filament (±0.03 mm) or you might have to post process the insides a bit.
Guranteed tight fit.
print as oriented.
no supports necessary.
These are a semi-permanent addition.
If you manage to remove them they WILL remove the baseplates from your talon mags.
So far I've been able to simply replace the baseplate on the talon, but it might surprise you when you take them off
Not for commercial use.
Please email me if interested in commercial licensing.
modeled after the magpul pmag, you'll have the spiffiest mags on the field.
tolerance is 0.15mm from the mag so print this with good quality filament (±0.03 mm) or you might have to post process the insides a bit.
Guranteed tight fit.
print as oriented.
no supports necessary.
These are a semi-permanent addition.
If you manage to remove them they WILL remove the baseplates from your talon mags.
So far I've been able to simply replace the baseplate on the talon, but it might surprise you when you take them off
Not for commercial use.
Please email me if interested in commercial licensing.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
