Tamiya M03 printable

Re-scaled the model to make printable might be a few mm bigger or smaller then a original m03.

Uses 3d printed spur an counter gear and a traxxas 2388X differential with printed drive cups for the diff.
Smallest pinion that can be used with the spur is 21t 48p

Uses all the same bearing sizes for a m03 and screw sizes

A alternative version of the C4 parts an addons to hold the battery better than with the top little clip that may break clean off.
Pin door variation will allow the usage of body clips to retain the ends of the C4 door for hopefully easier battery access.

Uses stock screws as well. There is some play in the original model in the steering suspension. I took that play using some delrin bushings i had laying around but washers or printed spacers would work to.

Gear box has held up so far with a 1900kv motor and 3cell lipo I would recommend getting the dogbones (ma15) in metal as I've twisted an snapped them even with 3d printed tires

Rear of chassis has be