Thingiverse
Tamiya NN2
von TITANIUM94010
5
Downloads
5
Likes
0
Makes
I've fixed the part, sorry for those who printed the one that was a little off.
Depending on print settings, the hole may be a little too tight to fit the 3mm rod. Use a hammer to get it, it is easy to pull out with pliers afterwards.
Although it is designed to fit perfectly, it may take a little sanding on some of the parts due to variations in printers and print settings.
It is best to print at 0.15mm or less layer height and a slow print speed.
Tamiya NN2 Part for XV01
Depending on print settings, the hole may be a little too tight to fit the 3mm rod. Use a hammer to get it, it is easy to pull out with pliers afterwards.
Although it is designed to fit perfectly, it may take a little sanding on some of the parts due to variations in printers and print settings.
It is best to print at 0.15mm or less layer height and a slow print speed.
Tamiya NN2 Part for XV01
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
