Thingiverse
Tandy 3000 keyboard foot
0
Download
0
Likes
0
Makes
I bought a Tandy 3000 keyboard and one of the foots was missing, so I made one in FreeCAD.
It works fine, it even locks in place like the original foot, as it is shown in the pictures.
**Improvements:**
It is not as tight as the original so it rattles a little, it might need to be about 0.5mm wider.
The two small pivot shafts can have some printing imperfections because of the overhangs. Maybe this could be avoided by making a multipart print.
**Print:**
Although rafts should not mater, I get better horizontal cylinders if I have them
Can send the FCStd file if requested.
It works fine, it even locks in place like the original foot, as it is shown in the pictures.
**Improvements:**
It is not as tight as the original so it rattles a little, it might need to be about 0.5mm wider.
The two small pivot shafts can have some printing imperfections because of the overhangs. Maybe this could be avoided by making a multipart print.
**Print:**
Although rafts should not mater, I get better horizontal cylinders if I have them
Can send the FCStd file if requested.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
