Thingiverse
Tape dispenser roll
von quakenxt
4
Downloads
3
Likes
0
Makes
The roll on tape dispenser are too brittle. Fortunately this will solve your problem if you own a 3d printer.
No need for supports or bed adhesion, insert the pin inside the wheel after printing.
It's better if you wait for the pin to cool down before removing it from the build plate. Otherwise it may warp.
No need for supports or bed adhesion, insert the pin inside the wheel after printing.
It's better if you wait for the pin to cool down before removing it from the build plate. Otherwise it may warp.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
